Workshop Technology For gas welding, the pressure desired at the welding torch for oxygen is 560 to 840 kN/m² 280 to 560 kN/m² 7 to 103 kN/m² 70 to 280 kN/m² 560 to 840 kN/m² 280 to 560 kN/m² 7 to 103 kN/m² 70 to 280 kN/m² ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The operation of producing cup shaped parts from flat sheet metal blanks by bending and plastic flow of metal, is known as Planishing Squeezing Drawing Coining Planishing Squeezing Drawing Coining ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The upsetting is a process of Bending of a bar Increasing the cross-section of a bar Reducing the cross-section of a bar Joining the two surfaces of metal under pressure after heating Bending of a bar Increasing the cross-section of a bar Reducing the cross-section of a bar Joining the two surfaces of metal under pressure after heating ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In forehand welding, the angle between the welding rod and the work is kept as 50°-60° 40°-50° 30°-40° 60°-70° 50°-60° 40°-50° 30°-40° 60°-70° ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For obtaining a cup of diameter 25 mm and height 15 mm by drawing, the size of the round blank should be approximately 46 mm 48 mm 44 mm 42 mm 46 mm 48 mm 44 mm 42 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For arc welding Any one of these Alternating current with low frequency is used Direct current is used Alternating current with high frequency is used Any one of these Alternating current with low frequency is used Direct current is used Alternating current with high frequency is used ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS