Chemical Engineering Basics For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship similar to that expressed by the pressure volume plot ? Temperature - entropy Enthalpy - entropy Temperature - pressure Enthalpy-pressure Temperature - entropy Enthalpy - entropy Temperature - pressure Enthalpy-pressure ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Lime contains about 90% CaO. Percentage CaO present in limestone is about 70 50 80 25 70 50 80 25 ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics What is the effect on the performance of the economiser in the thermal power plant boiler, if the feed water temperature is very low due to preheaters being out for repairs or starving of steam supply ? Scale formation rate on economiser tubes increases Economiser tube life increases due to handling of low temperature water Heat transfer efficiency of economiser increases due to picking up high heat from the flue gases It results in corrosion due to the condensation on the flue gas side of the economiser tubes due to handling of low temperature water Scale formation rate on economiser tubes increases Economiser tube life increases due to handling of low temperature water Heat transfer efficiency of economiser increases due to picking up high heat from the flue gases It results in corrosion due to the condensation on the flue gas side of the economiser tubes due to handling of low temperature water ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics The weight of a body at the centre of the earth is Infinite Zero None of these Same as on the surface of the earth Infinite Zero None of these Same as on the surface of the earth ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics The ratio of thermal & electrical conductivity is same for all the metals at the same temperature ; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) T² 1/T² 1/T T T² 1/T² 1/T T ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the Length of the pipe Density of the fluid Diameter of the pipe Velocity of the fluid Length of the pipe Density of the fluid Diameter of the pipe Velocity of the fluid ANSWER DOWNLOAD EXAMIANS APP