Engineering Drawing Elevation drawings will include information about ________. All of these Siding Roof pitch Window style All of these Siding Roof pitch Window style ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________. Eliminate the view Leave the view as is Use the left view instead None of these Eliminate the view Leave the view as is Use the left view instead None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Which of the following is one of the basic types of welded joints: T-joint Rear joint Angle joint Groove joint T-joint Rear joint Angle joint Groove joint ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the descriptive geometry method to create an auxiliary view the drafter should _________. Rotate the top line of the front view 45 degrees Rotate the snap grid to the same angle of the inclined plane Offset the top line of the front view 2 inches Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees Rotate the snap grid to the same angle of the inclined plane Offset the top line of the front view 2 inches Offset the right vertical line of the front view ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct iso-plane has been selected by scrolling through the iso-planes using the ________ key. F3 F1 F8 F5 F3 F1 F8 F5 ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is a rounded exterior blend between surfaces: Chamfer Round Fillet Taper Chamfer Round Fillet Taper ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS