Design of Masonry Structures If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be 1 Between 0 and 1 Greater than 1 1 Between 0 and 1 Greater than 1 ANSWER DOWNLOAD EXAMIANS APP
Design of Masonry Structures Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as __________ of the total vertical load on the most heavily loaded wall or column in the group 6 % 4 % 5 % 7 % 6 % 4 % 5 % 7 % ANSWER DOWNLOAD EXAMIANS APP
Design of Masonry Structures If the horizontal cross-sectional area of a wall is 1200 cm², then the basic stress shall be multiplied by a reduction factor equal to 0.6 0.95 0.75 0.85 0.6 0.95 0.75 0.85 ANSWER DOWNLOAD EXAMIANS APP
Design of Masonry Structures If ‘H’ is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be 1.5 H 0.75 H 1.0 H 0.85 H 1.5 H 0.75 H 1.0 H 0.85 H ANSWER DOWNLOAD EXAMIANS APP
Design of Masonry Structures Cement mortars richer than 1 : 3 are not used in masonry because(i) There is no gain in strength of masonry(ii) There is high shrinkage(iii) They are prone to segregation (i) and (ii) are correct (ii) and (iii) are correct Only (ii) is correct (i), (ii) and (iii) are correct (i) and (ii) are correct (ii) and (iii) are correct Only (ii) is correct (i), (ii) and (iii) are correct ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS