Computer Hardware
After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:

None of these
System's power supply
Floppy drive ribbon cable
Original IDE controller
System's floppy drive device driver

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
Which would you do first when troubleshooting a faulty monitor?

Power down the computer, then turn it on again to see if that corrects the problem
Check its connections to the computer and power source
Use a meter to check the CRT and internal circuitry for continuity
Power down the monitor, then turn it on again to see if that corrects the problem

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?

jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
jumper properly, partition, low level format, high level format
jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
jumper properly, auto-detect in CMOS, regular format

ANSWER DOWNLOAD EXAMIANS APP
MORE MCQ ON Computer Hardware