Computer Hardware
After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:

System's power supply
Floppy drive ribbon cable
Original IDE controller
System's floppy drive device driver
None of these

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
You run a super wing-ding diagnostic program on your PC, and it reports that your hard drive, microprocessor, RAM, and video card have seen better days. To resolve this problem you should:

replace everything at once and rerun the diagnostic
replace each part one at a time, rerunning the diagnostic before replacing the next part.
get another copy of the diagnostic program
run an exhaustive memory check
check to see if you have a software problem

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
To install a second IDE drive into a computer, you must

Set the master-slave jumper to slave on the second drive
Verify that you define the new drive as D: in the CMOS setup
Use the IDE configuration software to set the new drive as slave
Verify that you attach the drive to the connector at the end of the ribbon cable

ANSWER DOWNLOAD EXAMIANS APP
MORE MCQ ON Computer Hardware