Analog Electronics A U shaped, opposite-polarity material built near a JFET-channel center is called the heat sink. block. gate. drain. heat sink. block. gate. drain. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics When the Q point moves along the load line, VCE decreases when the collector current stays the same. None of these decreases. increases. stays the same. None of these decreases. increases. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics A 3 - phase diode bridge rectifier is fed from a 400 V rms, 50 Hz, 3 phase AC source. If the load is purely resistive, then peak instantaneous output voltage is equal to 400√ (2/3) V. 400√ 2 V. 400 / √ 3 V. 400 V. 400√ (2/3) V. 400√ 2 V. 400 / √ 3 V. 400 V. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics If the collector resistor is open, the collector voltage is high. low. unchanged. unknown. high. low. unchanged. unknown. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The ideal value of stability factor of a biasing circuit is 1. 10. 5. 100. 1. 10. 5. 100. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The common-mode voltage gain is equal to the voltage gain. greater than the voltage gain. smaller than the voltage gain. None of these equal to the voltage gain. greater than the voltage gain. smaller than the voltage gain. None of these ANSWER DOWNLOAD EXAMIANS APP