Automation System A typical NC system has which of the following components? All of these None of these Controller Tape input Machine tool All of these None of these Controller Tape input Machine tool ANSWER DOWNLOAD EXAMIANS APP
Automation System Historically, central systems were used because: semiconductor memory was not available memory was very expensive memory consumed a large amount of power All of these None of these semiconductor memory was not available memory was very expensive memory consumed a large amount of power All of these None of these ANSWER DOWNLOAD EXAMIANS APP
Automation System The "end-effector" of a robot: All of these is the robot "hand" may have a gripping action None of these can be an actual tool All of these is the robot "hand" may have a gripping action None of these can be an actual tool ANSWER DOWNLOAD EXAMIANS APP
Automation System The accuracy of a pick-and-place robot can be as good as: None of these 0.008 inches 3% + 0.05 inches + 0.0005 inches None of these 0.008 inches 3% + 0.05 inches + 0.0005 inches ANSWER DOWNLOAD EXAMIANS APP
Automation System What is the difference between integral and derivative control? integral control has slower response to an error signal. derivative control does not eliminate offset error All of these None of these derivative control responds to a change in the rate of change in the error signal integral control has slower response to an error signal. derivative control does not eliminate offset error All of these None of these derivative control responds to a change in the rate of change in the error signal ANSWER DOWNLOAD EXAMIANS APP
Automation System Which method uses the design analysis as a method for effecting the design? The direct method None of these All of these The iterative design method The design selection method The direct method None of these All of these The iterative design method The design selection method ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS