Manufacturing And Production Technology A twist drill is a None of these End cutting tool Front cutting tool Side cutting tool None of these End cutting tool Front cutting tool Side cutting tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is wrong as regard to down milling? The chips are disposed off easily and do not interfere with the cutting. The coolant can be poured directly at the cutting zone where the cutting force is maximum. The surface milled appears to be slightly wavy. It can not be used on old machines due to backlash between the feed screw of the table and the nut. The chips are disposed off easily and do not interfere with the cutting. The coolant can be poured directly at the cutting zone where the cutting force is maximum. The surface milled appears to be slightly wavy. It can not be used on old machines due to backlash between the feed screw of the table and the nut. ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The example of snag grinding is All of these Removing flash on forgings Trimming the surface left by spruces and risers on castings Grinding the parting line left on castings All of these Removing flash on forgings Trimming the surface left by spruces and risers on castings Grinding the parting line left on castings ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology What is the type of welding defect is caused due to stresses on heating and cooling called? Incomplete penetration Slag Entrapment (Inclusions) Shrinkage void Incomplete fusion Incomplete penetration Slag Entrapment (Inclusions) Shrinkage void Incomplete fusion ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. Calculate R.P.M. and energy requirement of the above circular electrodes assuming effective resistance between electrodes as 100 ohm. 6.8 rpm, 6 joules 22 rpm, 600 joules 2.17 rpm, 600 joules 5.03 rpm, 600 joules 6.8 rpm, 6 joules 22 rpm, 600 joules 2.17 rpm, 600 joules 5.03 rpm, 600 joules ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology For softer materials, the point angle of the drill is kept Any one of these More than 118° Equal to 118° Less than 118° Any one of these More than 118° Equal to 118° Less than 118° ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS