Computer Hardware
What is the most likely cause of an "FDD controller Failure" error message?

you did not set the jumper on the floppy drive to drive A
your computer's floppy drive is defective
None of these
you forgot to flash CMOS
you installed the floppy disk drive cable backward

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
When connecting a ribbon cable to a connector, how do you know which direction to plug it in?

It does not matter
The red line in the cable goes to the highest pin number
The blue or red line in the cable goes away from the power connector
The colored line in the cable goes to pin #1

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?

jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
jumper properly, partition, low level format, high level format
jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
jumper properly, auto-detect in CMOS, regular format

ANSWER DOWNLOAD EXAMIANS APP