Manufacturing And Production Technology A shaft has a dimension, φ9 +0.025⁺⁰∙⁰⁰⁹, the respective values of fundamental deviation and tolerance are −0.025, ±0.008 −0.009, ± 0.008 −0.009, 0.016 −0.025, 0.016 −0.025, ±0.008 −0.009, ± 0.008 −0.009, 0.016 −0.025, 0.016 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The guide-ways are of Any one of the listed here Flat type Dovetail type V-type Any one of the listed here Flat type Dovetail type V-type ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Relief angles on high speed steel tools usually vary from 20° to 30° 10° to 20° 0° to 3° 3° to 10° 20° to 30° 10° to 20° 0° to 3° 3° to 10° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the maximum chip thickness May not occur at the middle Occurs at the middle Depends upon the geometry of the tool Depends upon the material of the tool May not occur at the middle Occurs at the middle Depends upon the geometry of the tool Depends upon the material of the tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a plain milling cutter, the portion of the gash adjacent to the cutting edge on which the chip impinges is called Lead Face Land Fillet Lead Face Land Fillet ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The process of removing metal by a cutter which is rotated against the direction of travel of workpiece, is called Down milling Up milling Face milling End milling Down milling Up milling Face milling End milling ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS