Workshop Technology A sand employed on the faces of the pattern before moulding, is called Parting sand Green sand Loam sand Dry sand Parting sand Green sand Loam sand Dry sand ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In piercing operation, the clearance is provided on Half on the punch and half on the die Die Punch Either on punch or die depending upon designer's choice Half on the punch and half on the die Die Punch Either on punch or die depending upon designer's choice ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The process of decreasing the cross-section of a bar and increasing its length, is called Drawing down Peening Upsetting Spinning Drawing down Peening Upsetting Spinning ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Structural sections such as rails, angles, I-beams are made by Hot drawing Hot extrusion Hot rolling Hot piercing Hot drawing Hot extrusion Hot rolling Hot piercing ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The cross-section of a chisel is usually Rectangular Hexagonal Octagonal Square Rectangular Hexagonal Octagonal Square ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Carburising flame is used to weld Hard surfacing materials such as stellite Steel, cast iron, copper, aluminium etc All of these Brass and bronze Hard surfacing materials such as stellite Steel, cast iron, copper, aluminium etc All of these Brass and bronze ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS