Engineering Drawing A round is a rounded surface on the ________ corner of a part. Isoplane Inside Outside Radial Isoplane Inside Outside Radial ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________. 3/4" = 1'-0" 1" = 100' 1/8" = 1'-0" 1/4" = 1'-0" 3/4" = 1'-0" 1" = 100' 1/8" = 1'-0" 1/4" = 1'-0" ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing A partial auxiliary view usually shows only features on the _________ of the inclined line and not any projection of other planes. Hidden lines Plane Center lines None of these Hidden lines Plane Center lines None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________. Type @3 Type 3 and try to use the Dynamic Input readout to find the end point Type 3 back slash and enter Type 3 forward slash and enter Type @3 Type 3 and try to use the Dynamic Input readout to find the end point Type 3 back slash and enter Type 3 forward slash and enter ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing These units are based on inch-foot and yard measurements: International customary units U.S. metric units ISO international units U.S. customary units International customary units U.S. metric units ISO international units U.S. customary units ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This type of solid has two bases that are parallel equal polygons: Torus Cone Prism Pyramid Torus Cone Prism Pyramid ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS