Engineering Drawing A line with a tapering width can be easily created by using the ________ tool. Ellipse Polyline Circle Line Ellipse Polyline Circle Line ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing How can the drafter prevent Auto-CAD from placing or stacking another center mark on a circle when adding a diameter dimension to it? Explode the dimension and then erase the center mark It can't be done Use the trim tool to take away the stacked center mark Use the Properties dialog box to turn off the center mark of the dimension Explode the dimension and then erase the center mark It can't be done Use the trim tool to take away the stacked center mark Use the Properties dialog box to turn off the center mark of the dimension ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An architect often relies on a _________ to complete the set of technical drawings used in the design of an office building. Technical illustrator Construction superintendent Drafter Artist Technical illustrator Construction superintendent Drafter Artist ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In offset sections, offsets or bends in the cutting plane are all: 180 degrees 30, 60 or 90 degrees 90 degrees Either 90 or 180 degrees 180 degrees 30, 60 or 90 degrees 90 degrees Either 90 or 180 degrees ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In this type of concrete, the steel is pre-tensioned before the superimposed load is applied: Preloaded Aggregate Pre-stressed Reinforced Preloaded Aggregate Pre-stressed Reinforced ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________. Use the left view instead Leave the view as is Eliminate the view None of these Use the left view instead Leave the view as is Eliminate the view None of these ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS