Computer Networking A devices that links two homogeneous packet-broadcast local networks, is repeater None of these hub bridge gateway repeater None of these hub bridge gateway ANSWER DOWNLOAD EXAMIANS APP
Computer Networking How many hosts are attached to each of the local area networks at your site? 254 64 256 128 None of these 254 64 256 128 None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which command would you use to apply an access list to a router interface? ip access-group 101 in access-group ip 101 in access-list ip 101 in ip access-list 101 out ip access-group 101 in access-group ip 101 in access-list ip 101 in ip access-list 101 out ANSWER DOWNLOAD EXAMIANS APP
Computer Networking You want to run the new 802.1w on your switches. Which of the following would enable this protocol? Switch(config)# spanning-tree mode 802.1w Switch# spanning-tree mode 802.1w Switch(config)# spanning-tree mode rapid-pvst Switch# spanning-tree mode rapid-pvst Switch(config)# spanning-tree mode 802.1w Switch# spanning-tree mode 802.1w Switch(config)# spanning-tree mode rapid-pvst Switch# spanning-tree mode rapid-pvst ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following connectivity devices is used to extend a network on a purely mechanical basis? Router Active hub 802.6 Gateway Switch Router Active hub 802.6 Gateway Switch ANSWER DOWNLOAD EXAMIANS APP
Computer Networking In Cisco's Unified Wireless Solution, what is the split-MAC architecture? The split-MAC architecture uses MAC addresses to create a forward/filter table and break up broadcast domains. The split-MAC architecture uses MAC addresses to create a forward/filter table and break up collision domains. The split-MAC architecture allows the splitting of 802.11 protocol packets between the AP and the controller to allow processing by both devices. The split-MAC architecture uses MAC addresses on the wireless network and IP addresses on the wired network. The split-MAC architecture uses MAC addresses to create a forward/filter table and break up broadcast domains. The split-MAC architecture uses MAC addresses to create a forward/filter table and break up collision domains. The split-MAC architecture allows the splitting of 802.11 protocol packets between the AP and the controller to allow processing by both devices. The split-MAC architecture uses MAC addresses on the wireless network and IP addresses on the wired network. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS