Computer Networking A 4 KHz noiseless channel with one sample every 125 per sec, is used to transmit digital signals. Find the bit rate (bits per second) that are sent, if CCITT 2.048 Mbps encoding is used. 500 Kbps 8 Kbps 64 Kbps 32 Kbps None of these 500 Kbps 8 Kbps 64 Kbps 32 Kbps None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following is true regarding VTP? All switches are VTP servers by default. VTP is on by default with a domain name of Cisco on all Cisco switches. All switches are VTP transparent by default. All switches are VTP clients by default. All switches are VTP servers by default. VTP is on by default with a domain name of Cisco on all Cisco switches. All switches are VTP transparent by default. All switches are VTP clients by default. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To enable EIGRP, which of the following would you use?1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.02. Router1(config-if)# ipv6 router rip 13. Router1(config)# ipv6 router eigrp 104. Router1(config-rtr)# no shutdown5. Router1(config-if)# ipv6 eigrp 10 3, 4 and 5 1, 3 and 5 5 only 1 and 3 3, 4 and 5 1, 3 and 5 5 only 1 and 3 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be? The configuration register setting is incorrect. The newly upgraded IOS is not compatible with the hardware of the router. You didn NVRAM is corrupted. The configuration register setting is incorrect. The newly upgraded IOS is not compatible with the hardware of the router. You didn NVRAM is corrupted. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.2. The VTP management domain name of both switches must be set the same.3. All ports on both the switches must be set as access ports.4. One of the two switches must be configured as a VTP server.5. A rollover cable is required to connect the two switches together.6. A router must be used to forward VTP traffic between VLANs. 1 and 6 1, 2 and 4 2 and 4 3, 5 and 6 1 and 6 1, 2 and 4 2 and 4 3, 5 and 6 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following would be good reasons to run NAT?1. You need to connect to the Internet and your hosts don't have globally unique IP addresses.2. You change to a new ISP that requires you to renumber your network.3. You don't want any hosts connecting to the Internet.4. You require two intranets with duplicate addresses to merge. All of these 1, 2 and 4 3 only 2 and 4 All of these 1, 2 and 4 3 only 2 and 4 ANSWER DOWNLOAD EXAMIANS APP